How To Mold and Cast a Resin Sculpture ‑ Ghost Rider

Measure equal amounts of Smooth-Cast™ 325 Part A and Part B. Pre-tint Part B using So-Strong™ Yellow. Mix Part A and Pre-tinted Part B thoroughly, make sure to scrape the sides and bottom of container several times. Apply first layer in a irregular pattern leaving space for other colors.

Repeat this step several times using SO-Strong™ Yellow, Red, Black, and Orange. Once detail layers are brushed in and cured, fill the rest of the mold using Smooth-Cast™ 325 slightly tinted with SO-Strong™ Red.

PLEASE NOTE - You can change your colors and results may vary.

Allow Smooth-Cast™ 325 urethane resin to cure fully before demolding. Remove Free Form™ AIR support shell and slowly demold casting.