How To Use EpoxAmite™ to Create Carbon Fiber Composite Parts
Step 6: Applying Additional Layers of EpoxAmite™
Additional layers of mat are layered to create the part. EpoxAmite™ is used between each layer. Peel ply is applied over the carbon fiber. Next, a breather fabric is placed over the peel ply.The EZ~Spray™ Silicone 20 vacuum bag is repositioned.
The built in silicone gasket is pressed into the tool. This ensures proper alignment and a full seal. The vacuum hose is connected to the vacuum port. The vacuum pump must be capable of pulling 29 inches of mercury. Any small air voids are worked away from the part. The EpoxAmite™ is allowed to fully cure while under vacuum, eliminating imperfections.
Once the EpoxAmite™ has fully cured, the EZ~Spray silicone vacuum bag can be removed.
