How To Make a Quick Silicone Wound Prosthetic
Step 2: Creating a Negative Using Smooth‑Cast 300
Wear vinyl gloves for the remainder of the moldmaking process.
Spray Universal Mold Release® onto all surfaces of the sculpture.
To pre-mix Smooth Cast® 300 part A shake the container and then shake part B to pre-mix. Next, dispense Smooth Cast® 300 part A into a small measuring cup and then an equal amount of Smooth Cast® 300 part B into a seperate small measuring cup. Now you can pour the Smooth Cast 300® Part A into a mixing container and add Part B. Make sure you mix the liquid plastic thouroughly.
Pour the low viscosity Smooth Cast resin over the sculpt and after a few minutes the plastic will begin to cure.
